2010-2018 Audi a1/s1 removable magnetic number plate holders (mag plate style)

2010-2018 Audi a1/s1 removable magnetic number plate holders (mag plate style)

Our magnetic plate holder kits allow you to easily remove your number plate (front or rear) whenever you want. This can be used to take clean photos of your car, or if you want the plate-less look.

The kit includes 2 magnetic brackets, 2 screws, and 2 mounts which attach to the number plate; equipped with high quality 3M tape to ensure your plate never falls off.

The A1S1 magnetic plate holders are made of high quality steel, and the magnets are very powerful so you never have to worry about your plates falling off.

To fit-

-Remove original plate

-Screw the mounts without tape on them to the two holes in the boot of the car, in the right direction so the screws sit flush with the edge of the mounts. Do not over tighten the screws. Only tighten them until they feel tight enough, or you could risk damaging the plastic inside the boot.

-Place the brackets with the tape on top of the holders attached the car, so the magnets engage and sit flush.

-Make sure your plate has a clean surface to stick to.

-Remove the sticker paper

-Place the plate on the mounts, so that it is straight and in the right position.

-Add slight force to the places where the mounts are stuck on.

-Leave for 5 minutes to set, then you can remove your number plate by pulling it off, and the magnetic plate holders will be attached and ready to use!

The plate holders can also be used on the front if you have an OEM grill. We advise to use self tapping screws with the same counter-sink head so they fit flush with the mounts. If using the screws provided with the kit, you may need to drill small holes in the grill to be able to screw the screws in.

If you are wanting to add our magnetic plate holders to the front and rear, please order 2 sets.